Z3 Technology Z3-DM8168-PCI-RPS User Instructions page 62

.mtd=5 root=ubi0:rootfs rootfstype=ubifs ip=192.168.81.68:192.168.0.6:192.168.0.
1:255.255.0.0:Z3-Netra::off:8.8.8.8:8.8.4.4 demo=mcsenc_demo
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 224MB 1MB = 225MB total
Memory: 222796k/222796k available, 39348k reserved, 0K highmem
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000
fixmap : 0xfff00000 - 0xfffe0000
DMA : 0xffa00000 - 0xffe00000
vmalloc : 0xd0800000 - 0xf8000000
lowmem : 0xc0000000 - 0xd0000000
pkmap : 0xbfe00000 - 0xc0000000
modules : 0xbf000000 - 0xbfe00000
.init : 0xc0008000 - 0xc003f000
.text : 0xc003f000 - 0xc04b2000
.data : 0xc04b2000 - 0xc04f6ec0
SLUB: Genslabs=11, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:375
IRQ: Found an INTC at 0xfa200000 (revision 5.0) with 128 interrupts
Total of 128 interrupts on 1 active controller
GPMC revision 6.0
Trying to install interrupt handler for IRQ368
Trying to install interrupt handler for IRQ369
Trying to install interrupt handler for IRQ370
Trying to install interrupt handler for IRQ371
Trying to install interrupt handler for IRQ372
Trying to install interrupt handler for IRQ373
Trying to install interrupt handler for IRQ374
Trying to install type control for IRQ375
Trying to set irq flags for IRQ375
OMAP clockevent source: GPTIMER1 at 27000000 Hz
Console: colour dummy device 80x30
Calibrating delay loop... 1209.13 BogoMIPS (lpj=6045696)
pid_max: default: 32768 minimum: 301
Security Framework initialized
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
devtmpfs: initialized
TI81XX: Map 0x8ff00000 to 0xfe500000 for dram barrier
TI81XX: Map 0x40300000 to 0xfe600000 for sram barrier
omap_voltage_early_init: voltage driver support not added
regulator: core version 0.5
regulator: dummy:
NET: Registered protocol family 16
omap_voltage_domain_lookup: Voltage driver init not yet happened.Faulting!
omap_voltage_add_dev: VDD specified does not exist!
OMAP GPIO hardware version 0.1
OMAP GPIO hardware version 0.1
evm_init_begin
omap_mux_init: Add partition: #1: core, flags: 0
_omap_mux_get_by_name: Could not find signal i2c2_scl.i2c2_scl
_omap_mux_get_by_name: Could not find signal i2c2_sda.i2c2_sda
*********** z3_fpga_init returns 0
___________________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N 8
CONFIDENTIAL
( 4 kB)
( 896 kB)
( 4 MB)
( 632 MB)
( 256 MB)
( 2 MB)
( 14 MB)
( 220 kB)
(4556 kB)
( 276 kB)
62
th ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
DOC-USR-0057-02