Z3 Technology Z3-DM8168-PCI-RPS User Instructions page 56

Format
(UDP/TS Only)
Jumbo PES
(UDP/TS Only)
RTP Port
(RTP Only)
Output Format
Dest Address
Dest Port
Aux TS File Enable
(UDP Only)
___________________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N 8
CONFIDENTIAL
ADTS
LATM
None
1 AU, 2 AUs, 3 AUs, 4 AUs
0 – 9999 (8892 – 8898)
RTP
UDP
TSFILE
FILE
MPTS
192.168.x.y
(192.168.0.6)
0 – 9999 (5004)
True
False
th ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
Allows user to select between ADTS headers for AAC
and LATM headers.
This needs to be set for compliance with certain
ISDB-T decoders. Should otherwise be left as
"None".
If RTP format is selected, the port # associated with
that audio channel.
Output format of encoded stream.
RTP requires an SDP file for the receiver or the use
of the RTSP URL.
If UDP is selected, don't forget to check the value
of TS Rate to make sure it is in line with
expectation.
TSFILE will write audio and video to a TS file. If
this is selected, you should type the path/name of
the file in "Dest Address" (for example:
/media/sda1/example.ts to write to "example.ts"
on a drive connected to USB1)
FILE will write raw .h264 and raw .aac to 2
separate files. If this is selected, you should type
the path/name of the H264 file in "Dest Address"
(for example: /media/sda1/example.h264). If
audio is enabled, a companion .aac file is then
created (for example, for "example.h264" a
companion file "example_0.aac" is created).
MPTS will be supported in an upcoming release.
The IP address that the encoder is streaming to.
The port that the encoder is streaming to.
For UDP streaming only. If UDP is being streamed,
this allows the same UDP stream to be saved to a ts
file. The name of the file is specified in "Aux ts
file location."
56
DOC-USR-0057-02