Standby Mode; Led Light; Connecting Electrical Loads - Champion 201188 Operator's Manual

201188 - 300 PORTAbLE POwER STATiON

Standby Mode

The USB and 12V DC ports will remain in standby mode for 2
hours, then shut off if they do not supply at least 2W of power to
an external device. The AC port(s) will remain in standby mode for
1 hour, then shut off if they do not supply at least 2W of power to
an external device or appliance.
If the Power Station is left untouched with all outlets powered off
for 2 hours, it will shut itself OFF. The Power Station will not shut
off if it is plugged in and charging. In standby mode, the display
will shut off to preserve power, and the power button will remain
illuminated.
When the ports and outlets are powered on, the Power Station
consumes about the same amount of power as one light bulb.

LED Light

1. To turn on LED low power mode press LED light button one
time for low power, two times for high power, and three times
for SOS mode.
2. Press LED light button until LED light turns off.

Connecting Electrical Loads

Always remember to plug your appliances directly into the
Power Station and do not connect any of the several Power
Station "outputs" into any electrical outlet or connect to the
circuit breaker panel in your home. Connecting a Power Station
to your home's electric utility company's power lines, or to
another power source, called 'backfeeding' is a dangerous
practice that is illegal in many states and municipalities.
This action if done incorrectly could damage your Power
Station, appliances and could cause serious injury or death
to you or a utility worker when attempting to restore power
during an outage occurrence in the neighborhood who may
then unexpectedly encounter high voltage on the utility line
and suffer a fatal shock.
Whether injuries occur or not, if installed incorrectly and not to
applicable laws and codes, you may be subject to fines or the
utility company may disconnect your home power should this
practice be found in your home.
If the Power Station will be connected to a building electrical
system, those connections must isolate the Power Station
power from the utility power. You are responsible for ensuring
your Power Station's electricity does not backfeed into the
electric utility power lines. These connections must comply
with all applicable laws and codes – Consult your local utility
company or a qualified electrician to properly install this
connection.
21
OPERATiON
wARNiNG
