Table of Contents
Advertisement
4.1.2) Disassembly of the machine
To disassemble the machine:
– First lower the rear part and lock with pin
(29), block wheel (34) then reverse the pro-
cess described in § 4.1.
– Before disconnecting the pump unit, make sure
to have disconnected the hydraulic circuit and
the braking device; locate the hoses in support
(S) got on the frame of the pump unit.
If necessary, with the machine fully assembled and
the motor switched off , the clamps can always be
opened or closed manually.
NOTE: Under normal conditions, the time taken to
remove the machine from the rail is approximately
60 seconds.
FIG. 4a – SUPPORT
4.2) Moving the machine
(Ref. to Fig. 4b)
To move the machine along the track, the rear part must be raised to prevent the clamps knock-
ing against the Fastclip.
1 -
Pull and turn knob (29). The wheel arm will be freed.
2 -
Slightly raise the machine by means of
handlebar (08); lifting will be made easier by
the two gas springs, then release the knob (29)
to lock the machine fully up.
3
- Press brake release handle (50) against the
handlebar (08).
4
- Push the machine along the rail.
2
29
1
FIG. 4b – MOVING THE MACHINE
(Ref. to Fig. 4 and 4a)
S
50
3
08
Before every use:
– Check wheel for resistance, wheel should not be free rotating.
– Ensure wheel is clean, removing any dirt or mud.
– Check for signs of damage.
Every 6 months:
– Check for excessive braking on wheel. Wheel should roll along track when pushed,
wheel will slide if excessive braking occurs.
Clamp unit wheel
Before every use:
– Check cable, linkages, springs and wheel for signs of damage.
– Check linkages are free moving.
– Ensure brake cable moves without resistance.
– With brake released, check that wheel rotates freely.
– Check that when handlebar lever is in the raised position, the brake is engaged.
– Ensure that wheel is clean of dirt and mud.
– Check that, before assembly, the wheel does not rotate one full turn in either direction.
– Ensure coupling is free of dirt and mud.
Every 6 months
– Check wheel pockets for excessive wear. If braking effectiveness is compromised,
replace wheel.
– Check extension spring (see fi gure) on brake release handle (50) are undamaged.
– Check for wear on pivots.
– Ensure fasteners are secure.
– Check for wear on coupling, parts should mate securely.
– Clean all moving parts and lubricate as required.
4
10
23
extension
spring
50
Advertisement
Table of Contents
