Advertisement
Available languages
Available languages
Setup Instructions Continued
Inflating Instructions
CAUTION: Inflate by adult only. DO NOT overinflate, use high pressure air compressor to inflate, or exceed the recommended Design Working Pressure. Inflate
with cold air only.
1. Locate a clean area free of stones or other sharp objects to inflate the pool.
2. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot air pump.
The adequate air pressure: make sure the pool is firm to the touch but NOT hard – there should be small folds around the armrests, backrests and/or side
edges, and below the cup holders (if any). Also compare the pressure with that of the large main chamber.
3. Close and press the inflation valves into the unit to get a flat surface.
4. Check regularly to ensure the adequate air pressure during each use, especially on very hot or cold days.
FILL THE POOL WITH 1 INCH OF WATER. THEN, SMOOTH OUT THE WRINKLES FROM THE BOTTOM OF THE POOL BY BRUSHING OUTWARDS
FROM THE INSIDE OF THE POOL SO IT FILLS UP EVENLY. MAKE SURE THAT THE BASE OF THE POOL IS COMPLETELY FLAT AND LEVELED.
NOT FOLLOWING THIS STEP WILL MAKE THE POOL FILL UNEVENLY AND MAY LOOK MISSHAPEN. IF THE POOL IS UNEVEN, YOU MAY NEED TO
RESTART THE SETUP (FIGURE 2-3).
5. Pull all the outer walls up straight and make sure they are not under the pool floor. Also make sure to pull up the top ring, all around the pool, so that it fills evenly.
NOTE: IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS
NOT LEVEL ENOUGH, AND MUST BE CORRECTED. SEE "SITE PREPARATION" ABOVE.
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL MAKE ADJUSTMENT IMPOSSIBLE AFTER THIS POINT.
6. Now, as you continue filling, the inflated ring will rise as the water deepens. Once this is done, if your pool included a filter/pump system please refer back to
the "Swimming Pool Filter System" owner's manual and follow all instructions for the installation of the filter pump.
POOL MAINTENANCE & DRAINAGE
CAUTION
: ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
Do not add chemicals while the pool is occupied. This can cause skin or eye irritation. Concentrated chlorine solutions can damage the pool liner. In no event is
Polygroup
, our buyer/retailers, or any other party liable for costs associated with the loss of pool water, chemicals, or water damage. Keep spare filter cartridges on
®
hand. Replace cartridges every two weeks. We recommend the use of Polygroup
Pump or other accessories, visit our website at support.polygroupstore.com or call Polygroup
EXCESSIVE RAIN: To avoid damage to the pool and overfilling, immediately drain rain water that causes the water level to be higher than the FILL LINE.
How to Drain Your Pool and Long-Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Remove the protective foam ring on the drainage cap.
3. Follow these steps for water drainage:
a) Turn the drain cap
b) Return the drain
counterclockwise
8
1
c) Flip the drain cap
cap from the valve
and reinsert it to
the drain valve
2
Filter Pump with all of our aboveground pools. To purchase a Polygroup
®
Customer Service.
®
2
1
d) Push and turn the
e) The drain valve is
drain cap clockwise
now open, water will
for about a quarter
begin to flow out.
turn (90
o
) to unlock
3
Filter
®
f) Attach a 5/8" garden
hose to the drain valve
Advertisement
