Polygroup SUMMER WAVES Quick Start Manual

WARNING
1. Recommended user's weight: 10 – 30 kg.
2. For outdoor use only.
3. For domestic use only.
4. Keep children in your direct line of sight, stay close, and actively supervise them when they are in or near this pool, and when you are filling and emptying this pool. When searching
for a missing child, check the pool first, even if the child is thought to be in the house.
5. Empty pool completely after each use, and store the empty pool in such a way that it does not collect water from rain or any other source.
6. Keep unsupervised children from accessing the pool by installing fencing or other approved barrier around all sides of pool. State or local laws or codes may require fencing or
other approved barriers. Check state or local laws and codes before setting up the pool.
7. Do not leave toys inside the pool when finished using it, since toys and similar items might attract a child to the pool. Position furniture (e.g., tables & chairs) away from pool, so that
children cannot climb on it to gain access to the pool.
8. Children can be drowned in very small amounts of water. Empty the pool when not in use.
9. Do not install the paddling pool over concrete, asphalt or any other hard surface.
10. Keep the instructions for further reference.
11. Pool and pool accessories are to be assembled and disassembled by adults only.
12. Never leave your child unattended - drowning hazard.
Setup Instructions
1. Location: Select a flat, level area of firm, compacted soil at least 2 m (78.7") away from any structures or obstructions (e.g. fence, garage, stones, overhanging branches, laundry lines and
electrical wires, and free of any sharp objects.)
IMPORTANT: DO NOT install the product on mud, sand, soft or loose soil, deck, balcony, platform, wooden surfaces, concrete, asphalt or any hard surfaces. Certain grass types such as St.
Augustine and Bermuda may grow through the liner. Grass growing through the product is not a manufacturing defect.
2. Check the product for tears or punctures. Do not use a damaged product or one with defects.
3. Locate the water slide (if any) out of direct sunlight to reduce the likelihood of scalding.
4. To Inflate: Pump air in through the air valves one by one, starting from the base. When finished, close the valve caps and push the valves into the product to get a flat surface.
IMPORTANT: Always fully inflate all air chambers. The inflated product should be firm but not too hard. Do not over-inflate or use a high-pressure air compressor to avoid leak or damage.
If you cannot push the valve back into the product, deflate slightly.
5. To Deflate: Squeeze the base of valves to release all the air. Close the valve caps when finished.
Polygroup Trading Limited Unit 606, 6th Floor, Fairmont House,
No.8 Cotton Tree Drive, Central, Hong Kong.
1
support.polygroupstore.com
AGES
2+
EN