Step 2: Install Symbio™ 700 - Trane Tracer Concierge BMTC015ABC012000 Installation Instructions Manual

System for small buildings pre-packaged control panel and display

Hide thumbs Also See for Tracer Concierge BMTC015ABC012000:

Table of Contents

Step 2: Install Symbio™ 700

If applicable to this site, install the Symbio™ 700 rooftop / split system equipment and controls

and either BACnet MS/TP or Air-Fi

in the equipment along with the applicable adapter board. The connection between the Symbio

700 and adapter board is also completed in the factory. Use the screw terminals provided on

the Symbio 700 controller for BACnet MS/TP connection(s). Use the screw terminals provided

on the adapter board for connection to the Air-Fi

applications.

Important:

Communication is enabled with the advanced version of the controller,

including BACnet and Air-Fi Wireless communication.

Figure 2.

Symbio 700 and BACnet MS/TP wiring terminations

Important: Before applying power to the Air-Fi Wireless WCI (when applicable), power down

the Symbio 700 controller and equipment. Once the wiring connections between the WCI and

Symbio 700 adapter board are complete, apply power to the Symbio 700 equipment controller

and WCI together.

Wireless. In all cases, the Symbio 700 is factory installed

Wireless WCI for communicating

BAS-SVN141E-EN

Table of Contents