Table of Contents
Advertisement
disconnection in the conditions specified by class III
overvoltage;
use unions with IP55 or higher protection when con-
necting hoses, pipes or cable glands;
the electrical system upstream of the automation sy-
stem must comply with the relevant regulations and be
constructed to good workmanship standards;
this appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved;
before starting the automation system, ensure that
there is no-one in the immediate vicinity;
before proceeding with any cleaning or maintenance
work on the automation system, disconnect it from the
electrical mains;
special care must be taken to avoid crushing between
the part operated by the automation system and any
fixed parts around it;
children must be supervised to ensure that they do not
play with the equipment;
that the drive cannot be used with a driven part incor-
porating a wicket door unless the drive can only be
operated with the wicket door in the safe position;
install any fixed control at a height of at least 1,5m and
within sight of the door but away from moving parts;
after installation, ensure that parts of the door do not
extend over public footpaths or roads;
when the appliance is provided with a separate stop
button, that stop button shall be unambiguously iden-
tifiable;
install the automation exclusively on gates operating
on flat surfaces, that is, they are not installed on an up
or down tilt;
install exclusively on gates that are sturdy enough and
suitable to withstand the loads generated by the auto-
mation itself;
do not subject the automation to direct jets of water,
such as sprinklers or pressure washers;
if the automation system exceeds 20 kg in weight,
it must be handled using safety lifting devices (IEC
60335-2-103: 2015);
provide appropriate safety protections in order to avoid
crushing and becoming trapped between the moving
guided part and any surrounding fixed elements;
make sure that any protection or safety devices, in ad-
dition to the manual release, work correctly;
place the automation identification plate at a clearly
visible point;
keep the manuals and technical files of all the devices
used to create the automation;
at the end of the automation installation it is advisable
to hand over the manuals relating to the warnings in-
tended for the end user;
ATTENTION !
Frequently examine the installation for imbalance
where applicable and signs of wear or damage to
cables, springs and mounting. Do not use if repair
or adjustment is necessary.
ATTENTION !
The automation system component packaging
material must be disposed of in full observance of
current local waste disposal legislation.
Key Automation reserves the right to amend
these instructions if necessary; they and/
or any more recent versions are available at
www.keyautomation.it.
EN
17
Advertisement
Table of Contents
