Table of Contents
Advertisement
SYMBOLOGY
V
Volts
Direct Current
No Load Revolutions per Minute (RPM)
BPM
Blows per Minute (BPM)
Anti-vibration System
Read operator's manual.
Regulatory Compliance Mark (RCM).
This
regulatory requirements.
Do not dispose of electric tools
together
material. Electric tools and electronic
equipment that have reached the end
of
their
separately
environmentally compatible recycling
facility.
FUNCTIONAL DESCRIPTION
6
5
4
3
2
1
1. Side handle
2. Clamping lever
3. Depth gauge rod
4. SDS Plus bit
holder
5. Release collar
6. Mode selector
7. Trigger
product
meets
with
household
life
must
be
and
returned
7
12
11
10
8. Forward/reverse swtich
9. Handle
10. AUTOSTOP™ indicator
LED
11. ONE-KEY™ indicator
LED
12. Dust extractor
connection
WARNING
specific
operator's manual supplied with your charger
and battery.
Inserting/ Removing the Battery
To insert the battery, slide the pack into the body of
the tool. Make sure it latches securely into place.
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
is not in use.
WARNING
may be hazardous.
To reduce the risk of injury, always use a side
applicable
handle when using this tool. Always brace or
hold securely.
Adjusting the Side Handle Position
waste
1. Loosen the side handle by unscrewing the side
handle grip until the side handle rotates freely.
2. Rotate the side handle to the desired position.
collected
3. Tighten the side handle grip securely.
to
an
For use with the Dust Extractor
The
MILWAUKEE
Dedicated Dust Extractor plugs directly into the
32mm SDS PLUS Rotary Hammer. For Dust
Extractor assembly and operation, refer to the Dust
Extractor manual.
1.
Press in the clamping lever.
8
2.
Slide the depth gauge rod backward or forward
until it is set for the desired depth.
NOTE: The drilling depth is the distance between
9
the tip of the bit and the tip of the depth gauge rod.
3. Release the clamping lever.
WARNING
mended for this tool. Others may be hazardous.
Installing Drill Bits and Chisels
NOTE: Only use accessories with SDS or SDS Plus
shanks.
Be sure that the shank of the bit is clean. Dirt particles
may cause the bit to line up improperly. Do not use
bits larger than the maximum recommended capacity
of the drill because gear damage or motor overload-
ing may result. For best performance, be sure that
the bit is properly sharpened and the shank is lightly
greased before use.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For
charging
instructions,
Always lock the trigger or remove
the battery pack
Only use
accessorie
reco
mmended
for thi
M18
®
Setting the Depth Gauge
Always remove
changing or removing accesso
read
the
any time the tool
s
s tool. Others
FDDEL32
32mm
Drilling Depth
battery pack before
-
-
Advertisement
Table of Contents
