Aintenance Of Rain Gauge; Maintenance Of Rain Gauge; Troubleshooting; Specifications - Ventus W140 User Manual

MAINTENANCE OF RAIN GAUGE

1. Rotate the rain collector in anticlockwise direction.
2. Gently remove the rain collector.
3. Clean and remove any debris or insects.

TROUBLESHOOTING

Problem / Symptom
Strange or no measurement of
Rain Sensor
Strange or no measurement of
Thermo Sensor
display on the outdoor temperature
display
and (Signal lost for 15
minutes)
and (Signal lost for 1 hour)

SPECIFICATIONS

MAIN UNIT
Dimensions
Weight
Battery
Support channels
INDOOR TEMPERATURE
Temp. unit
Displayed range
Operating range
Resolution
Accuracy
Display modes
Memory modes
Alarm
INDOOR HUMIDITY
Displayed range
Operating range
Resolution
1. Check the drain hole in the rain collector.
2. Check the balance of the rain gauge.
1. Check the radiation shield.
2. Check the sensor casing.
1. Change new batteries to the rain gauge.
2. Relocate the main unit and sensor closer to each other.
3. Make sure the main unit is placed away from other
electronic appliances that may interfere with the wireless
communication (TVs, computers, microwaves).
4. If problem continues, reset both main unit and the sensor.
95 x 155 x 23 mm (W x H x D)
212g without batteries
2 x AA size 1.5V batteries (Alkaline recommended)
Wireless sensor (Rain gauge, thermo sensor)
°C or °F
-40°C to 70°C (-40°F to 158°F) (< -40°C: LO; > 70°C: HI)
-10°C to 50°C (14°F to 122°F)
0.1°C or 0.1°F
+/- 1°C or 2°F typical @ 25°C (77°F)
Current, Min and Max, Historical data for past 24 hours
Max & Min from last memory reset (with time stamp)
Hi / Lo Temperature Alert
20% to 90% RH (< 20%: LO; > 90%: HI) (Temperature between 0°C to 60°C)
20% to 90%RH
1%
Solution
14