Wireless Signal Reception; Data Clearing - Ventus W140 User Manual

To Enable / Disable the HI / LO Alert
1. Press [ ALERT ] button until the desired area is selected.
2. Press [ ALARM ] button to turn the alert on or off.
3. Press [ ALERT ] button to continue to next setting.
NOTE:
1. The unit will automatically exit setting mode in 5 seconds if no key is pressed.
2. When ALERT alarm is on, the alert LED indicator, the area and type of alarm that triggered the
3. To silence the Alert alarm beeping, press the [ SNOOZE/LIGHT ] button, or let the beeping
alarm automatically turn off after 2 minutes.

WIRELESS SIGNAL RECEPTION

No sensor
The wireless sensor is capable of transmitting data wirelessly over an approximate operating
distance of 150m range (line of sight).
Occasionally, due to intermittent physical obstruction or other environment interference, the signal
may be weaken or lost.
In the case that the sensor signal is lost completely, you will need to relocate the display main unit
or the wireless sensor closer to each other.

DATA CLEARING

During installation of the wireless sensor, the sensor was likely to be triggered, resulting in
erroneous rainfall measurements. After the installation, user may clear out all the erroneous data
from the Display Main Unit, without needing to reset the clock and re-establish pairing.
1. Press and hold [ HISTORY ] button for 3 seconds.
2. Press [ UP ] or [ DOWN ] button to choose "YES" or "NO".
3. Press [HISTORY]
Signal searching Strong signal Weak signal
13
Signal lost