Advertisement
Quick Links
thermOweld
INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - BAR TO REBAR
BRE-7
Follow instructions on reverse side
for proper use of shim stock. Place
rebar and copper strip into mold as
shown.
† Depending on weld type and rebar size, mold may go around or be placed onto rebar.
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
®
The Contractors Choice
BRE-17
†
Follow instructions on reverse side for proper use of
packing pad. Place copper bar into mold as shown.
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
ECN 2552 REV "G" 03/06/13
34-5381-93
Advertisement
Related Manuals for Burndy Continental Industries thermOweld BRE-7
Summary of Contents for Burndy Continental Industries thermOweld BRE-7
- Page 1 thermOweld ® The Contractors Choice INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - BAR TO REBAR BRE-7 BRE-17 † Follow instructions on reverse side Follow instructions on reverse side for proper use of for proper use of shim stock. Place packing pad. Place copper bar into mold as shown. rebar and copper strip into mold as shown.
- Page 2 GENERAL SAFETY INSTRUCTIONS WELDING PROCEDURE 1. Check mold tag for material to be welded and proper cartridge 1. Always wear proper clothing, safety glasses and gloves when size to use. exothermic welding. 2. Make sure all surfaces and conductors are clean, dry and are 2.
Need help?
Do you have a question about the Continental Industries thermOweld BRE-7 and is the answer not in the manual?
Questions and answers