Table of Contents
Advertisement
54. Lower Front Panel
79. Control Box
80. Transformer Box
CLEANING INSTRUCTIONS
1. Remove all ice from dispenser.
2. Disconnect the dispenser's electrical power.
3. Remove top cover on manually filled dispensers, or ice
machine front panel, if an ice machine is assembled
on top of dispenser.
4. Remove upper front panel's two screws.
5. Remove three thumbscrews holding the auger upper
bearing bracket in place and remove the auger upper
bearing bracket, along with the auger.
6. Remove the ice chute and actuator lever assembly by
removing thumbscrews (see Fig. 6A). The assembly
must be slid down while holding the ice outlet door
open.
7. Remove the lower front panel's four screws and lay
forward in drain area (see Fig. 6B).
8. Remove the ice outlet door, switch box, and mounting
bracket (see Fig. 6C) by lifting up and forward. This
assembly can be laid on top- of the lower front panel
removed in Step 6.
9. Remove auger access panel by removing four
thumbscrews (see Fig. 6E).
10. Remove lower agitator coupling and agitator flight
extension (see Fig. 6D).
11. The dispenser liner and cold plate can now be cleaned
and sanitized with a solution of 3 oz. of Manitowoc Ice
Machine Cleaner per gallon of water (see Fig. 6D).
12. The agitator flights, upper bearing, shaft, and upper
bearing bracket assemblies can be cleaned and
sanitized with same solution (see Fig. 6E).
13. The dispensing auger can be disassembled by
removing the stainless steel pin at the top of the auger.
Remove the pin, and the auger flights will slide off the
shaft for cleaning (see Fig. 6E).
14. Rinse all parts with clean water before assembling.
WARNING: Do not use metal scrapers or abrasives on the
bin liner or plastic parts. These will destroy the smooth
surfaces.
Fig. 6
Fig. 6A
67. Soda Manifold
Fig. 6C
37. Electrical Box
Switch
41. Door — Living Hinge
46. Bracket Ice Outlet
Door Mounting
Advertisement
Table of Contents
