Warnings - Pentair Westlock 2300 Ex ia Series Installation & Operating Instructions Manual

Installation & Operating Instructions.
Westlock 2300 Ex ia Position Monitor – ATEX / IECEx Certified.
With Mechanical Switches, Inductive Proximity Sensors or Magnum Proximity Switches.
3.0 Warnings.
NOTE: Before installation of this product, please ensure that the product and its certification is suitable for the intended
application.
If the equipment is likely to come into contact with aggressive substances, then it is the responsibility of the user to take
suitable precautions that prevent it from being adversely affected, thus ensuring that the type of protection provided by
the equipment is not compromised.
The installer shall ensure compliance to the certificate conditions for each of the certified components installed.
All components installed shall be treated as separate intrinsically safe circuits.
When the enclosure is manufactured from aluminium ignition sources due to impact and friction sparks may occur.
This shall be considered when the monitor is being installed, particularly in locations that specifically require
Group II, Category 1G equipment.
The maximum dust layer shall be no greater than 5mm (T
WARNING: Electrostatic hazard, clean only with damp cloth.
This symbol warns the user of possible danger. Failure to heed this warning may lead to personal injury or
death and/or severe damage to equipment.
This symbol identifies information about operating the equipment in a particular manner that may damage it or
result in a system failure. Failure to heed this warning can lead to total failure of the equipment or any other
connected equipment.
This symbol draws attention to information that is essential for understanding the operation and/or features of
the equipment.
280 N. MIDLAND AVE., STE 258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
1/20/2016
135°C).
5
PENTAIR VALVES & CONTROLS.
TECHUK-95 REV 1 ECN#12787-E 3 of 9