Table of Contents
Advertisement
Display assembly
Non-touch displays are spared only at the subcomponent level. Non-touch assemblies are not spared as
whole units.
Before disassembling the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Place the computer in "Battery Safe mode"
3.
Disconnect all external devices connected to the computer.
4.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5.
Remove the following components:
a.
Service doors
b.
Hard drive
c.
Keyboard
d.
Top cover
Disassemble the display assembly:
1.
Position the computer upright on a flat surface and open the display as far as possible.
2.
Flex the top (1) of the bezel, the inside edges of the left and right sides (2), and then the right side of the
bottom (3) and the left side of the bottom (4) of the bezel until it disengages from the display enclosure.
TIP:
The bottom, inside of the bezel is secured to the display enclosure with double-sided adhesive.
When removing the bezel, be sure to remove the tape from the bezel so that it remains connected to the
display.
(Service doors on page
(Hard drive on page
34)
(Keyboard on page
37)
(Top cover on page
41)
(Battery Safe mode on page
28).
Component replacement procedures
27).
65
Advertisement
Table of Contents
