Electrical Connection; Attaching The Plastic Wedges; Adjusting The Legs; Hot Surface Warning - Beko B5RFNE294W User Manual

WARNING:
The product's power cable must be
unplugged during installation. Fail-
ure to do so may result in death or
serious injuries!
WARNING:
If the door span is too narrow for
the product to pass, remove the
door and turn the product side-
ways; if this does not work, contact
the authorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to direct sun-
light or keep it in damp environments.
• Your product requires adequate air circu-
lation to function efficiently. If the
product will be placed in an alcove, re-
member to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
• Check if the rear wall clearance protec-
tion component is present at its location
(if provided with the product).
• If the component is not available, or if it
is lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient oper-
ation of the product.

4.2 Electrical Connection

Do not use extension or multi sock-
ets in power connection.
Damaged power cable must be re-
placed by Authorized Service.
When placing two coolers in adja-
cent position, leave at least 4 cm
distance between the two units.
• Our firm will not assume responsibility
for any damages due to usage without
earthing and power connection in compli-
ance with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
• Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.

4.3 Attaching the Plastic Wedges

The condenser of the refrigerator is located
at the rear. To minimize power consump-
tion and increase energy efficiency the top
of the condenser must be pulled back and
secured as shown in the picture. When the
condenser is pulled backwards, the brack-
ets at the top right and left locks and the
condenser's position is secured.

4.4 Adjusting the Legs

If the product is not in balanced position,
adjust the front adjustable legs by rotating
them to right or left.

4.5 Hot Surface Warning

The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
EN / 14
EN
FR
DE
NL