Using The Footswitch With The Dsp - Crate GUITAR AMPLIFIER GTD120212 Owner's Manual

GTD120/212 Guitar Amplifier w/DSP and Channel Tracking

Using the Footswitch with the DSP

The Crate three-button footswitch supplied with the GTD120/212 allows access to an addi-
tional DSP preset for each channel of the amplifier. When the footswitch is connected to the
amplifier as shown below, the "original" DSP presets are active for each channel when the #3
footswitch LED is illuminated. These are referred to as "DSP Bank A." When the #3 button is
switched and the LED is off, a second DSP preset may be stored and recalled for each chan-
nel — "DSP Bank B."
Note: DSP Bank B presets are only accessible when the footswich is connected to the ampli-
fier. When the footswitch is not connected, only DSP Bank A is accessible.
8
"LEFT" jack
Switch #2:
Switch #1: LED ON = HIGH GAIN CH/OVERDRIVE CH
LED ON = HIGH GAIN CH LED OFF = CLEAN CH
LED OFF = OVERDRIVE CH
[only when Switch #2 is activated (LED ON)]
"RIGHT" jack
Switch #3:
LED ON = DSP BANK A
LED OFF = DSP BANK B