Using The Footswitch With The Dsp - Crate Flexwave FW120 Owner's Manual

FlexWave120/212 Guitar Amplifier w/DSP and Channel Tracking

Using the Footswitch with the DSP

The Crate three-button footswitch supplied with the FlexWave120/212 allows access to an
additional DSP preset for each channel of the amplifier. When the footswitch is connected to
the amplifier as shown below, the "original" DSP presets are active for each channel when the
#3 footswitch LED is illuminated. These are referred to as "DSP Bank A." When the #3 button
is switched and the LED is off, a second DSP preset may be stored and recalled for each
channel — "DSP Bank B."
Note: DSP Bank B presets are only accessible when the footswich is connected to the ampli-
fier. When the footswitch is not connected, only DSP Bank A is accessible.
8
FOOTSWITCH
EXT DSP
BANK A
SPKR
BANK B
"LEFT" jack
Switch #2:
LED ON = HIGH GAIN CH/OVERDRIVE CH
Switch #1:
LED ON = HIGH GAIN CH LED OFF = CLEAN CH
LED OFF = OVERDRIVE CH
[only when Switch #2 is activated (LED ON)]
CHANNEL INSERT
CLEAN / OD
HIGH GAIN
"RIGHT" jack
Switch #3:
LED ON = DSP BANK A
LED OFF = DSP BANK B