Installation; 5-4.1. Camera Connection; 5-4.1. Camera Connection; 5-4.2. Installation Of The Monitor - Clover LCD2084 Instruction Manual

5-4. Installation

5-4.1. Camera Connection

▫ Connection of 6pin MINI DIN Cameras
Connect the supplied cameras to the Camera Input (6pin mini DIN jack) on the left side of the
system as shown in [Fig. 5-2 Rear & Side View].
Connect the BNC cameras (not included) to the Camera Input (BNC connector) on the left
side of the system as shown in [Fig. 5-2 Rear & Side View].

5-4.2. Installation of the Monitor

[Fig. 5-4 Removing three screws]
▫ Desktop
- Place the system on the flat surface.
- Do not place this product near a bathtub, kitchen sink, wet basement, over a radiator, or heat
generator.
▫ Installation of the system on the wall
- Place the system on the flat surface with soft fabric as shown in Error! Reference source
not found.].
- Separate the mounting bracket by removing three screws on the rear of the system as
shown in Error! Reference source not found.]
- The wall mounting bracket is not included in the system and refer to the manufacturer's
instructions on how to install it to the wall.
[Fig. 5-5 Separating the mounting bracket]
25

5. Installation