Clover LCD2084 Instruction Manual page 21

1. REC Key
- Press this key to start recording.
- In order to stop recording, press this key again or click the REC button on the MENU window
and then the following message will be appeared. Click the OK button or press the ENTER
key.
2. ENTER Key
- Press this key to select items or save menu settings.
3. EXIT Key
- Press this key to exit menu with saving.
4. MENU Key
- Press this key in the Live mode to display the Video Enhancement menu for VGA output (See
section 6-8.2 for more detailed information).
5. DOWN Key
- Used to decrease Audio Volume for the system.
6. UP Key
- Used to increase Audio Volume for the system.
7. TALK Key
- See section 6-7.4.2 for information.
8. Stand-by Power Mode Button
- Turn the LCD Panel (Screen) On or Off
- Even though the LCD Screen is turned off by pressing this button, the system will be
continued to work.
- See section 6-4 for more information.
- The red LED is lit when the Power switch on the rear of the system is ON.
9. Remote Control Signal Receiver
- Do not block the receiver port on the unit. Doing so may cause the remote controller to
function improperly.
21
5. Installation