Table of Contents
Advertisement
AXIS P32 Network Camera Series
Configure your device
8. Create a second rule and select the same Condition as in the first rule.
9. In the list of actions, select Toggle I/O while the rule is active, and then select the port the AXIS I/O Indication LED is
connected to. Set the state to Active.
10. Save the rule.
Other scenarios where AXIS I/O Indication LED can be used are for example:
•
Configure the LED to turn on when the camera starts, to indicate the presence of the camera. Select System ready as
a condition.
•
Configure the LED to turn on when live stream is active to indicate that a person or a program is accessing a stream from
the camera. Select Live stream accessed as a condition.
Set up the intrusion alarm
Important
To set up an intrusion alarm you need the AXIS Dome Intrusion Switch C.
With a dome intrusion switch mounted inside the camera, you can receive a notification if someone removes the camera dome.
Before you start
•
Connect the intrusion alarm switch to pin 1 (ground) and pin 3 (digital input) of the camera's I/O connector.
Configure the input port
1. Go to System > Accessories > I/O ports.
2. For Port 1:
2.1 Select Circuit closed.
Add a recipient:
3. Go to System > Events > Recipients and click Add recipient.
4. Type a name for the recipient.
5. Select Email.
6. Type an email address to send the email to.
7. The camera doesn't have it's own email server, so it will need to log into another email server to be able to send mails. Fill
in the rest of the information according to your email provider.
8. To send a test email, click Test.
9. Click Save.
Create a rule
10. Go to System > Events > Rules and add a rule.
11. Type a name for the rule.
12. In the list of conditions, under I/O, select Digital input.
13. In the list of ports, select Port 1.
14. In the list of actions, under Notifications, select Send notification to email.
15. Select a recipient from the list or go to Recipients to create a new recipient.
17
Advertisement
Table of Contents
