Table of Contents
Advertisement
Malfunction
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
Detergent residue on
the damp laundry.
Detergent residue on
the dry laundry.
At the water supply
feed hose is leaking water.
Water is leaking from
the water drain hose.
Cause and Troubleshooting
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The imbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Detergents can contain water-insoluble substances,
which deposit on the laundry.
Start the programTo rinse.
▶
Detergents can contain water-insoluble substances,
which deposit on the laundry.
Brush the laundry after washing and drying.
▶
The water inlet hose is not correctly / firmly
connected.
Connect the water supply hose correctly.
1.
→
"Connecting the water inlet hose", page 15
Tighten the coupling properly.
2.
Water drain hose is damaged.
Replace the damaged water drain hose.
▶
Water drain hose is not connected correctly.
Connect the water drain hose correctly.
▶
→ "Drainage connection types", page 16
TroubleshootingNL
49
Advertisement
Table of Contents
