Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Program centrifugal
run does not start.
fizzing, hissing
loud.
Loud noise during
spinning.
Clapping, clattering
in the pump.
Slurping, rhythmic
suction sound.
wrinkling.
Detergent or laundry detergent
softer drips from
the cuff and collects on
the door or in the cuff
fold.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
48
Cause and Troubleshooting
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
The appliance is not leveled properly.
→ "Adjusting the device", Page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 16
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
A foreign object has entered the pump.
→
"Cleaning the drain pump", page 37
▶
Pump is active, the solution is being pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load quantity is too high.
Reduce the load during the next wash.
▶
Inappropriate program set for the type of fabric.
Select a suitable program for the type of fabric.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing the liquid detergent and fabric softener,
▶
pay attention to the marking in the detergent drawer
and do not dose above that.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Start the programCentrifuge.
▶
Anti wrinkleis activated.
Select a suitable program for the type of fabric.
▶
Drain pipe or water drain hose is clogged.
Advertisement
Table of Contents
