Installation Of Appliance - Cata MDS 7205 X Installation, Use And Maintenance Instructions

4

INSTALLATION OF APPLIANCE

Installation of the appliance shall be
performed by Silverline Authorized
Service. Our company shall not be
held responsible for damages that may
occur on people, surroundings or other
materials due to incorrect installation
of the appliance.
Inspect the appliance after opening the
packaging. Do not perform the connec-
tion of the appliance in case of a trans-
port damage.
Carefully read the installation pages
for the installation of the accessories.
Take off and remove all packaging
materials and adhesive tapes from the
cooking compartment and the door
before operating the appliance.
The appliance may be installed in two
different ways: under the counter or
inside a wall cabinet. Installation
dimensions to be used for these
options are provided below.
Do not install the appliance behind a
decoration or a furniture cover. This
would pose a risk due to overheating.
Cutting operations on the furniture
shall be performed before the installa-
tion of the appliance. Remove any
burrs. They may have an adverse
effect on the functioning of electrical
units.
Use protective gloves to prevent inju-
ries.
You shall provide the clearances
shown in the drawings for ventilation
and cooling inside the cabinet or cup-
board to ensure correct operation of
the appliance.
26.03.2020
Walls of furniture where the appliance
is installed shall be resistant to heat.
Particularly if the side walls are made
of coated particleboard, the coating
shall resist up to 120 ˚C. Plastic or
adhesive coating that are not resistant
to the specified heat may get deformed
and damaged.
A support that may handle the weight
of the oven shall be put under it while
placing the oven.
For safety reasons, direct contact of
the appliance with electrical parts shall
be prevented when the installation is
complete.
Parts that provide insulation and pro-
tection shall be installed so that they
cannot be removed by using any tool.
We recommended you to install the
appliance in a wall cabinet to ensure a
more efficient air circulation.
Rear compartment of the cabinet in the
kitchen unit shall be removed to
ensure a more efficient air circulation.
We recommended you to provide a
minimum clearance of 70 mm from the
rear of the kitchen unit where the appli-
ance is installed.
We do not recommend installation of
the appliance near a refrigerator or
deep freezer. Otherwise, the perform-
ance of such appliances shall be
affected adversely due to the dissi-
pated heat.
To make your oven ready for opera-
tion, have the location it shall be
placed in built with the electrical instal-
lation. Then, call the Silverline Author-
ized Service.
OVEN USER GUIDE ENGLISH
INSTALLATION OF APPLIANCE
13