Table of Contents
Advertisement
CHANNEL
Before you begin:
Make sure the unit is connected to antenna or cable.
1
Press Q MENU and use H I J K to select CHANNEL select
Start Scan (option), then press OK.
CHANNEL
Antenna/Cable
Start Scan
Favorite
Channel List
Show/Hide
Channel Number
Channel Label
Move
Select
2
Adjust the following items.
Antenna/Cable
Select signal type.
1
Use H I to select Antenna/Cable, then use J K to select
the item.
When Antenna is selected, the TV detects
any Off-the-Air antenna signals. It searches
Antenna
for ATSC (Digital) and NTSC (Analog)
channels available in your area.
When Cable is selected, the TV detects
signals supplied by cable. It searches for
Cable
ATSC (Digital), NTSC (Analog), and Cable
channels available in your area.
Back to Contents
Cable
Adjust
Back
Start Scan
Be sure the RF cable is correctly connected to this unit and you
are registered with your cable TV provider when you install
cable channels.
1
Use H I to select Start Scan, then press OK.
Auto Tuning
Analog
Digital
RF CH
Found
Please press MENU key to exit
When the scanning and memorizing of available
●
channels is completed, the lowest memorized channel
will be displayed.
Note(s)
After setting Start Scan, using CH +/– skips unavailable channels
●
automatically.
If you are not receiving a signal from your cable service, contact the cable
●
provider.
If you press B or Q MENU during auto scan, the setup of TV channels
●
will be cancelled.
Even if Start Scan is completed, the channel setting will be lost if the AC
●
power cord is unplugged before the unit goes into standby mode by
pressing B .
The PIN code will be required once you set a PIN code in the Child and
●
ratings lock L p. 25.
If you want to change your PIN code, follow the instruction for Change
●
Password L p. 25.
23
.
English
Continued on next page.
Advertisement
Table of Contents
