Samsung RS68A8840WW/EF User Manual page 183

Installation
NOTE
• A newly installed filter may cause the water dispenser to spurt water briefly. This is
because air has entered the water line.
• This replacement process may involve the refrigerator to drip water onto the floor. If
this happens, wipe up with dry cloths.
38 English
Untitled-8 38
1. Shut off the main water supply.
2. Connect the water supply line to the
inlet side of the filter to the end.
3. Connect the dispenser line to the outlet
side of the filter.
4. Check if there is any leak. If not, fix the
lines with the clips.
5. Put the water filter into place and fix it
with the clips.
6. Reset the water filter replacement
alarm. (For detailed instructions, see the
"Resetting or dismissing the water filter
replacement alarm" section on page 48.)
7. When replacing is complete, flush 10
litres of water (or dispense the water
for 6 - 7 minutes) to remove impurities
from the water line.
CAUTION
When adjusting the length of the water
line tubing, make sure to smooth out the
cut surface at a right angle. This is to
prevent a water leak.
2021-01-11 2:59:47