Table of Contents
Advertisement
Spot Cleaning
You can conveniently clean a specific area that has a a lot of
cookie crumbs, dust, and etc.
■ Move the vacuum cleaning robot to the location where you want to
perform a spot clean.
Main unit button
▶
2time
- In Spot cleaning mode, the vacuum cleaning robot cleans an area
with a length of 1.5m and a width of 1.5m.
- When cleaning is completed, the vacuum cleaning robot will
display End, Stop, and Stand by.
When the vacuum cleaning robot is docked with the charger
station, spot cleaning is not supported.
NOTE
• Each time you press the Turbo button, the Turbo icon on
the display panel is turned on or off sequentially. When the
CAUTION
Turbo icon is turned on, you can start cleaning in Turbo
mode.
• Each time you press the Dust Sensor button, the Dust
Sensor icon on the display panel is turned on or off
sequentially. When the Dust Sensor icon is turned on, you
can start cleaning in Dust Sensor mode.
30_ operating
Remote control
button
1. Set the mode.
2. Cancel the mode.
Configuration
Sequence
Dust Sensor Mode
Cleaning Complete
About 1.5m
Silence Mode
Turbo Mode
Advertisement
Table of Contents
