Table of Contents
Advertisement
en
Home Connect
If the door seal is damaged, a large amount of heat
■
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
:
Warning – Risk of serious damage to health!
The appliance will become very hot during the cleaning
function. The non-stick coating on baking trays and tins
is destroyed and noxious gases are released. Never
clean non-stick baking trays and baking tins using the
cleaning function. Only clean enamelled accessories
using the cleaning function.
Setting the self-cleaning function
Press the menu button.
1.
The operating modes menu opens.
Select the "Self-cleaning" operating mode.
2.
Cleaning setting 3 is suggested. You can start the
cleaning process immediately using the "Start/stop"
button or
select a different cleaning setting using the rotary
3.
selector.
Press the "Start/stop" button to start the cleaning
4.
operation.
Ventilate the kitchen when the cleaning function is
running.
The cooking compartment door locks shortly after
operation starts. The
H
mechanism appears on the right-hand side of the status
bar next to the elapsing duration.
The cooking compartment door cannot be opened until
H
the
symbol goes out in the status bar.
Once the cleaning has finished
An audible signal sounds. The oven stops heating.
"Finished" appears in the status bar. Use the
to switch off the audible signal.
Cancelling the cleaning operation
Use the "On/off" button to switch off the oven. The
cooking compartment door cannot be opened until the
H
symbol goes out in the status bar.
Adjusting the cleaning setting
Once cleaning starts, the cleaning setting can no longer
be changed.
You can set the cleaning to run overnight
In the section "Time settings", you can find out how to
delay the end time. This allows you to use the oven at
any time throughout the day. ~ "Time-setting options"
on page 15
Once the cleaning function has ended
Once the cooking compartment has cooled down, use
a damp cloth to wipe off the ash that has been left
behind in the cooking compartment and around the
appliance door.
Note:
Very bad soiling may cause white deposits to
remain on the enamel surfaces. This is residue from the
20
symbol for the locking
0
food and is harmless. It does not affect performance.
You can remove these residues using lemon juice if
required.
oHome Connect
T his appliance is Wi-Fi-capable and can be remotely
H o m e C o n n e c t
controlled using a mobile device.
If the appliance is not connected to the home network,
the appliance functions in the same way as an oven
with no network connection and can still be operated
via the display.
The availability of the Home Connect function depends
on the availability of Home Connect services in your
country. Home Connect services are not available in
every country. You can find more information on this at
www.home-connect.com.
Notes
Ensure that you follow the safety instructions in this
■
instruction manual and that you comply with these
even when you are away from home and are
operating the appliance via the Home Connect app.
You must also follow the instructions in the
Home Connect app.~ "Important safety
information" on page 5
Operating the appliance directly from the appliance
■
always has priority. During this time, it is not possible
to operate the appliance using the Home Connect
app.
Setting up
To set up Home Connect for your appliance, you
button
require the following:
Your appliance, which must be connected to the
■
mains and switched on,
A smartphone or tablet with the latest version of the
■
iOS or Android operating system,
The Home Connect app,
■
The supplied Home Connect installation instructions,
■
And your appliance within range of the Wi-Fi signal
■
for your home network
The app guides you through the entire process. Follow
the instructions in the app.
Remote Start
In order to start and operate your appliance via the
Home Connect app, you must activate remote start. If
remote start has been deactivated, you can only display
the operating statuses in the Home Connect app and
implement appliance settings.
Note:
Some of the operating modes can only be started
on the oven.
Remote start is automatically deactivated:
if you open the oven door 15 minutes after remote
■
start has been activated.
Advertisement
Table of Contents
