Filling With Rinse Aid And Making The Setting - Nordmende DSSN60BL Instruction Manual

When the conditions of use of such products and the machine settings are appropriate,
•
they ensure savings in salt and/or rinse aid consumption.
Contact the detergent manufacturers if you are not obtaining good wash results (if your
•
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage: If you want to obtain better results while using combined detergents,
add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid
setting to the (1) lowest position.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in such
programs.
Warning: Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position ( 6 ) and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
•

Filling with rinse aid and making the setting

To put rinse aid, remove the rinse aid compartment cap by turning
compartment with rinse aid until the rinse aid level indicator becomes
close it by turning it in a way that the nails will correspond to one another. By checking the rinse
aid level indicator on the detergent dispenser, you can understand whether or not your machine
needs rinse aid. A dark indicator
is left when wiped by
Warning: Use only those rinse aid materials which are allowed for use in the machine. As rinse
aid residues left as a result of overflowing will create extremely high amounts of foam and thus
reduce the washing performance, remove the excess amount of rinse aid by wiping it with a rag.
Rinse aid is used to prevent the stay of white water drops, lime
stains, white film strip-shaped stains that may form on the dishes,
as well as to increase the drying performance. Contrary to the
popular beliefs, it is used not only for obtaining shinier dishes but
also for obtaining sufficiently dried dishes. For this reason, care
should be taken that there is adequate amount of rinse aid in the
rinse aid compartment and only polishing material produced for
use at dishwashers should be used.
If the rinse aid lamp on the control panel becomes on fill the rinse
aid compartment with rinse.
b means that there is rinse aid in the compartment, while a
light indicator
need to fill the compartment with
rinse aid.
The rinse aid level adjuster can be
set to a position between 1 and 6.
Factory setting for rinse aid is the
position 3. You need to increase
the degree of the adjuster if water
stains form on your dishes after a
wash, whereas
decrease the degree if a blue stain
hand.3
a shows that you
you need
15
it.1 Fill the rinse aid
dark;2 refit the cap and
to