Page 2
Thank you for choosing this product. This User Manual contains important information on safety and instructions intended to assist you in the operation and maintenance of your appliance. Please take the time to read this User Manual before using your appliance and keep this book for future reference.
1. SAFETY INSTRUCTIONS 1.1. General Safety Warnings • Read these instructions carefully before using your appliance and keep this manual for future reference. Please check the packaging of your machine before installation and the outer surface of the machine once the packaging has been removed. Do not operate the machine if it appears damaged or if the packaging has been opened.
1.2. Installation Warnings • Choose a suitable and safe place to install your machine. • Only original spare parts should be used with the machine. Unplug the machine before installation. Your machine must only be installed by an authorised service agent. Installation by anyone other than an authorised agent may cause your warranty to be void.
Page 7
• it for other purposes. Commercial use will void the guarantee. Do not stand, sit or place loads on the open door of the dishwasher. Only use detergents and rinse aids produced specifically for dishwashers. Our company is not responsible for any damage that may occur due to misuse.
Page 8
be performed by an authorised service company, otherwise the warranty will be void. Before repair work, the machine should be disconnected from the mains. Do not pull the cable to unplug the machine. Switch off the water tap. Operation at a low voltage will cause a decline in performance levels.
Page 9
CE Declaration of Conformity We declare that our products meet the applicable European Directives, Decisions and Regulations and the requirements listed in the standards referenced. Disposal of your old machine The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
2. INSTALLATION new hose before connecting. 2.1. Machine positioning WARNING: Connect the hose directly to the water inlet tap. The pressure When positioning the machine, place it in supplied by the tap should be a minimum an area where dishes can be easily loaded of 0.03 MPa and a maximum of 1 MPa.
2.5. Electrical connection panel of your dishwasher, the machine should be placed in a space of the 2.6. Electrical connection dimensions shown in the figure below. WARNING: Your machine is set to operate at 220-240 V. If the mains voltage supply to your machine is 110 V, connect a transformer of 110/220 V and 3000 W between the electrical connection.
3. TECHNICAL SPECIFICATIONS 3.2 Technical specifications 10 place Capacity settings Dimensions (mm) Height 850(mm) Width 450(mm) Depth 598(mm) Net weight 40 kg Operating 220-240V voltage / 50 Hz frequency Total current 10(A) Total power 3.1. General appearance 1900(W) 1. Worktop 2.
Page 13
centres. • Contact a relevant recycling centre to obtain information about disposal of different materials. PACKAGING AND THE ENVIRONMENT • Packaging materials protect your machine from damage that may occur during transportation. The packaging materials are environmentally friendly as they are recyclable. The use of recycled material reduces raw material consumption and therefore decreases waste production.
4. BEFORE USING a short washing program to protect your machine against corrosion. THE APPLIANCE 4.1. Preparing your Dishwasher for first use • Check whether the electricity and supply water specifications match the values indicated in the installation instructions for the machine. •...
1.3. Test Strip 4.3. Test Strip Run water Keep the Shake the Wait Set the hardness level of through tap strip in strip. (1min.) your machine. (1min.) water (1sec) NOTE: Level is set 3 as default. If the water is well water or has a hardness level above 90 dF, we recommend that you use filter and refinement devices.
4.8. Filling the detergent In order to change the rinse aid level, follow the below steps before turning on Push the latch to open the dispenser and the machine: pour in the detergent. • Turn the knob to the “off” position. Close the lid and press it until it locks in place.
5. LOADING YOUR Upper Baske DISHWASHER Height adjustment Turn the Rail Stop Clips, at the ends of the For best results, follow these loading rails, to the sides to open them (as shown in guidelines. the image below), then pull out and remove We recommend that you place large items the basket.
5.2.Alternative Basket Loads Lower Basket Top Basket Incorrect Loads Important Note for Test Laboratories For detailed information required for tests according to EN normatives and a softcopy of the manual, please send the model name and serial number to the following address: dishwasher@standardtest.info EN - 14...
6. PROGRAMME TABLE Detergent A: 5cm³ Duration Programme Description B1: 15cm³ (min) B2: 25cm³ Prewash To rinse heavily soiled dishes before a wash programme. Standard programme for dishes which are used daily but are not A+B2 (Reference) heavily soiled. A faster programme for dishes which are used daily but are not Super 50’...
7. THE CONTROL PANEL Selection knob to the 'Off' position. During a delay, the light corresponding to the remaining time is switched on. 7.1. Changing a Programme Follow the steps below to change a programme while in operation. Press the Start/Pause button. Rotate the Programme Selection Knob (3) to switch the machine on and select a suitable programme for your dishes.
7.2. Cancelling a Programme NOTE: Do not open the door before the Follow the steps below to cancel a programme is complete. programme while in operation. NOTE: Leave the door slightly open at Press and hold the the end of a wash programme to speed up Start/Pause button for 3 seconds.
8.CLEANING AND the filters. Replace the filter insert, and MAINTENANCE rotate it clockwise (4). • Never use your Dishwasher without a Cleaning your Dishwasher is important filter. to maintain the machine’s service life. • Incorrect fitting of the filter will reduce Oil and lime may build up in your the washing effectiveness.
9. TROUBLESHOOTING FAULT POSSIBLE CAUSE TROUBLESHOOTING Your Dishwasher is not plugged in. Plug your Dishwasher in. Switch your Dishwasher on by pressing the Your Dishwasher is not switched on. On/Off button. Fuse blown. Check your indoor fuses. The programme does not start.
Page 24
FAULT POSSIBLE CAUSE TROUBLESHOOTING Use the correct amount of detergent, as Not enough detergent used. instructed in the programme table. Rinse aid dosage and/or water Increase rinse aid and/or water softener softener setting set too low. level. Whitish stains remains on dishes.
AUTOMATIC FAULT WARNINGS AND WHAT TO DO TROUBLE CODE POSSIBLE FAULT WHAT TO DO Start/ Wash Pause Make sure the water inlet tap is open and water is flowing. Insufficient water Separate the inlet hose from the tap and clean the filter of the hose. Contact for service if the error continues.
11. THE PRODUCT FICHE NORDMENDE Supplier's trade mark DW48WH Supplier's model Capacity of dishwasher The energy efficiency class Annual energy consumption in kWh per year (AEc) ( 280 Cycle )* Energy consumption (Et) (kWh per cycle) 0,73 Off-mode power consumption (W) (Po) 0,50 Left-on mode power consumption (W) (Pı)
Need help?
Do you have a question about the DW48WH and is the answer not in the manual?
Questions and answers