Table of Contents
Advertisement
en
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
Note
Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.
If the rinse aid refill indicator or salt refill
indicator is defective and you would like to
switch it off, proceed as follows:
Switching "Add rinse aid" off
and on:
Switch on the appliance with the main
switch
.
1
Keep pressing button M/OK
the "rinse aid" setting is displayed.
By pressing buttons – or +
can select a set value between 0 and 6.
The factory setting is "rinse aid 4".
To switch off, select position "0"
Press the button M/OK
value is saved and you are returned
to the Start menu.
If the set value "0" is selected, rinse aid
is not dispensed. Low rinse aid is not
displayed.
18
Switching "Refill salt" and
therefore the water softening
system off and on:
If the setting is "0" (off) the softening
system is switched off. Possible lack of
salt will not be indicated.
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
until
2
hardness.
, you
3
The set
2
Switch on the appliance with the main
switch
.
1
Keep pressing button M/OK
the "Hardness" setting is displayed.
By pressing buttons – or +
a set value between 0 (off) and 7.
The factory setting is "Hardness 4".
Switch off by selecting the set value "0"
Press the button M/OK
value is saved and you are returned
to the Start menu.
Note
until
2
, select
3
The set
2
Advertisement
Table of Contents
