Disassembly Procedure - Mitsubishi Electric Mr.Slim PUZ-HA30NHA2 Service Manual

15

DISASSEMBLY PROCEDURE

PUZ-HA30NHA PUZ-HA36NHA
OPERATING PROCEDURE
1. Removing the service panel and top panel
(1) Remove 3 service panel fixing screws (5 × 10) and slide
the hook on the right downward to remove the service
panel.
(2) Remove screws (3 for front, 3 for rear/5 × 10) of the top
panel and remove it.
2. Removing the fan motor (MF1, MF2)
(1) Remove the service panel. (See Figure 1.)
(2) Remove the top panel. (See Figure 1.)
(3) Remove 5 fan grille fixing screws (5 × 10) to detach the
fan grille. (See Figure 1.)
(4) Remove a nut (for right handed screw of M6) to detach the
propeller. (See Photo 1.)
(5) Disconnect the connectors, CNF1, CNF2 on controller cir-
cuit board in electrical parts box.
(6) Remove 4 fan motor fixing screws (5 × 25) to detach the
fan motor. (See Photo 2.)
3. Removing the electrical parts box
(1) Remove the service panel. (See Figure 1.)
(2) Remove the top panel. (See Figure 1.)
(3) Disconnect the indoor/outdoor connecting wire and power
supply wire from terminal block.
(4) Remove all the following connectors from controller circuit board,
fan motor, linear expansion valve, thermistor <Outdoor
pipe>, thermistor <Discharge>, thermistor <Outdoor 2-phase
pipe>, thermistor <Outdoor>, high pressure switch, low
pressure switch, solenoid valve coil <Four-way valve> and
solenoid valve coil <Bypass valve>. Then remove a screw
(4 × 8) from the valve bed to remove the lead wire.
Pull out the disconnected wire from the electrical parts box.
<Diagram symbol in the connector housing>
• Fan motor (CNF1, CNF2)
• Linear expansion valve (LEV-A, LEV-B and LEV-C)
• Thermistor <Outdoor pipe> (TH3) (TH32) (TH33)
• Thermistor <Discharge> (TH4)
• Thermistor <Outdoor 2-phase pipe, Outdoor> (TH7/6)
• High pressure switch (63H)
• Low pressure switch (63L)
• 4-way valve coil (21S4)
• Bypass valve coil (SV2)
(5) Remove the terminal cover and disconnect the compressor
lead wire.
(6) Remove an electrical parts box fixing screw (4 × 10) and
detach the electrical parts box by pulling it upward. The
electrical parts box is fixed with 2 hooks on the left and 1
hook on the right.
PUZ-HA30NHA2
Figure 1
Fan
grille
fixing
screws
Grille
fixing
screws
Photo 1
Propeller
Nut
Photo 3
92
PUZ-HA36NHA2
PHOTOS & ILLUSTRATION
Top panel fixing screws
Slide
Photo 2
Front panel
Fan motor fixing screws
Fan motor fixing screws
Controller circuit board(C.B.)
Top panel
Service panel
Fan grille
Service panel
fixing screws
Fan
motor
Electrical
parts box
Electrical
parts box
fixing screw
Terminal block
(TB1)
Valve bed
Screw
Terminal cover
Compressor
(MC)