Table of Contents
Advertisement
INSTALL THE RANGE
REPLACE THE WIRE COVER
8
Replace the wire cover on the range back
by sliding its two lower retaining tabs into
the slots and replacing the screw removed
earlier. Make sure that no wires are pinched
between the cover and the range back.
ANTI-TIP DEVICE INSTALLATION
9
WARNING:
• Range must be secured by Anti-Tip
bracket supplied.
• If the Anti-Tip device supplied with the
range does not fit this application, use
the universal Anti-Tip device WB2X7909.
• Unless properly installed, the range
could be tipped by stepping or sitting on
the door. Injury may result from spilled
hot liquids or from the range itself.
• Anti-tip bracket attaches to the floor to hold
either rear range leg. When fastening to the
floor, be sure that the screws do not penetrate
electrical wiring or plumbing. If you cannot
be sure of this, use shorter screws that will
not penetrate through the flooring.
A
Decide whether the anti-tip bracket will be
installed on the right or left side of the
range location.
If the bracket side of the range is next to a
B
cabinet or wall, place the bracket 1
the cabinet or wall. If there is no adjacent
cabinet, determine where the location of the
range side (painted outside panel) will be.
Place the bracket so that the distance between
the mounting holes (center line) is 1
from the side panel. Position the bracket so
the back hole is 2
Screw the bracket securely to the floor with
C
the screws provided. The screws are self-
drilling in wood, plywood, particle and chip
board, and most metal framing. If attaching
to masonry, you can buy suitable screws
and/or anchors at hardware stores. Use a
masonry
drill to drill
the required
holes.
Installation Instructions
" from
9
⁄
16
"
3
⁄
8
" from the back wall.
⁄
7
16
Anti-tip
"
2
7
⁄
16
bracket
ANTI-TIP DEVICE INSTALLATION
9
(cont.)
D
Slide the range back toward the wall, being
careful not to damage the sides or top of
the range, or the adjacent cabinets. Make
sure one of the rear leveling legs securely
engages into the anti-tip bracket.
10
LEVEL THE RANGE
For proper cooking and baking, the range
must be leveled. Leveling legs are located
on each corner at the base of the range.
A
Install the oven shelves
(see Using the oven
section for instructions).
Put a spirit level or a
glass measuring cup
partially filled with water
on one of the oven
shelves.
B
Turn the legs clockwise
to raise the range and
counterclockwise to
lower the range. Adjust
the leveling legs until
the range is level.
FINAL INSTALLATION CHECKLIST
11
• Check to make sure the circuit breaker is
closed (RESET) or the circuit fuses are
replaced.
• Be sure power is in service to the building.
• Check to be sure that all packing materials
and tape have been removed. This will
include tape on metal panel under control
knobs (if applicable), adhesive tape, wire
ties, cardboard and protective plastic. Failure
to remove these materials could result in
damage to the appliance once the appliance
has been turned on and surfaces have heated.
• Check to make sure that the rear leveling
Wall
leg is fully inserted into the Anti-Tip bracket
and that the bracket is securely installed.
• Be sure all range controls are in the OFF
position before leaving the range.
19
Advertisement
Table of Contents
