ICON Health & Fitness PRO-FORM POWER 595i User Manual page 26

Locate the Reed Switch (101) and the Magnet
(103) on the left side of the Pulley (49). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in.
(3 mm). If necessary, loosen the #8 x 3/4" Truss
Head Screw (95), move the Reed Switch slightly,
and then retighten the Truss Head Screw. Reattach
the Motor Hood (not shown) with the #8 x 3/4"
Screws (not shown) and run the treadmill for a few
minutes to check for a correct speed reading.
Top
View
1/8 in.
101
95
SYMPTOM: The incline of the treadmill does not
change correctly
a. Hold down the Stop button and insert the key into
the console. Next, release the Stop button. Then,
press the Stop button and then press the Incline
increase or decrease button. The treadmill will
automatically rise to the maximum incline level and
then return to the minimum level. This will recalibrate
the incline system. If the incline system does not
begin calibrating, press the Stop button again, and
then press the Incline increase or decrease but-
ton again. When the incline system is calibrated,
remove the key from the console.
SYMPTOM: The walking belt slows when walked on
a. If an extension cord is needed, use only a 3-con-
b. If the walking belt is overtightened, treadmill per-
103
49
c. Your treadmill features a walking belt coated with
d. If the walking belt still slows when walked on, see
26
ductor, 14-gauge (2 mm 2
than 5 ft. (1.5 m).
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and walk on
the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.
b
2–3 in.
Idler Roller Screws
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances to
the walking belt or the walking platform unless
instructed to do so by an authorized service
representative. Such substances may deterio-
rate the walking belt and cause excessive wear.
If you suspect that the walking belt needs more
lubricant, see the front cover of this manual.
the front cover of this manual.
) cord that is no longer