Hardware Description; Front View - Watchguard Firebox T85-PoE Hardware Manual

Firebox T85-PoE Hardware Guide

Hardware Description

Front View

Front view of the Firebox:
Failover
The Failover indicator is lit when there is a WAN failover from the primary external interface to the
backup interface. After the external interface connection fails back to the primary external
interface, the indicator is not lit.
Network Interface Status Indicators
The Firebox T85-PoE has eight network interfaces. On the front panel, the network interfaces are
labeled 7, 6, 5, 4, 3, 2, 1, 0. There are two status indicators for each interface. The light blinks
when data is sent and received. The speed of the blink increases as the data flow increases.
Indicator
1000
Yellow
10/100
Green
Module
This indicator is lit when an interface module is installed.
Status
The Status indicator is red when there is a management connection to the device. The Status
indicator is lit for 30 seconds after you connect to the device with the Fireware Web UI or the
command line interface. It is also lit when the device is polled by WatchGuard System Manager.
Mode
The Mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot send traffic to the external network.
9
Indicator Interface Status
On Link speed: 1000 Mbps
On Link speed: 10 Mbps or 100 Mbps
WatchGuard Technologies, Inc.