Setting Up Transfer Station Ii Hardware - Watchguard Transfer Station II Quick Start Manual

Getting Started

Setting up Transfer Station II hardware

Motorola Solutions provides you a:
Power cable
l
Ethernet cable
l
Station ID and Slot # stickers
l
Motorola Solutions offers rack options for mounting multiple transfer stations in the same location.
For information, contact your sales representative.
To set up the Transfer Station II hardware:
1. Use the provided Station ID/Slot # stickers to label the Transfer Station II slots.
Tip: The labels assume an alphabetic Station ID, for example, A, then slot numbers 1
through 8.
Important! Enter the Station ID and Location that you entered when you
configured the Transfer Station II for use with your Evidence Library software. The
Station ID combined with the Location indicates a specific V300 Camera to Evidence
Library.
2. Connect the Ethernet cable to the Ethernet connector on the back of the Transfer Station II.
3. Connect the power cable to the power connector on the bottom of the Transfer Station II and plug
the power cable into an electrical outlet
4. Power the transfer station ON using the switch on the back. The serial number is on the bottom.
5. Connect the other end of the Ethernet cable to a computer that you have set up to access the
Transfer Station II factory default configuration web page.
Tip: Use the Transfer Station II factory default IP address to access the default
6
Transfer Station II
Quick Start Guide WGD00172 Rev B