Making Measurements With The Hp 8480 Series Power Sensors; Procedure - HP E4419B User Manual

Power Meter Operation

Making Measurements with the HP 8480 Series Power Sensors

Making Measurements with the HP 8480 Series
Power Sensors
This section applies to all HP 8480 series power sensors. It does not apply
to the HP E-series power sensors.
For the HP 8480 series power sensors there are two methods of providing
correction data to the power meter:
A inputting the individual calibration factor for a frequency prior to
making the measurement, or
B using sensor calibration tables.
This section describes how to make measurements without using sensor
calibration tables, that is, inputting the individual calibration factor for a
frequency prior to making the measurement. This method is
advantageous if you are only measuring at one frequency, as entering all
the calibration data in this instance is not required.
To make measurements without sensor calibration tables perform the
following steps:
1. Zero and calibrate the power meter. Before carrying out the
calibration you must set the reference calibration factor of the
power sensor.
2. Set the calibration factor value for the frequency of the signal you
want to measure.
3. Take a reading.

Procedure

The following procedure details how to make a measurement on
channel A. To make a measurement on channel B use the same procedure
using the equivalent channel B softkeys.
1. Ensure that no power is applied to the power sensor.
Zero
2. Press .
Cal
3. Press Zero A
seconds, the wait symbol is displayed.
4. Press .
Cal
5. Connect the power sensor to the POWER REF output.
2-18
Get other manuals https://www.bkmanuals.com
. During zeroing, which takes approximately 10
HP E4419B User's Guide