Table of Contents
Advertisement
5019_719_01132_GB
1-06-2007
Fixing the Hob to the worktop. Flush fitted model.
Important: The following procedure shall
be carried out by competent technical
personnel only. The hob can be installed
on different types of materials, such as
masonry, metal, bare wood and heat
resistant laminate coated wood (90°C).
Cut an opening into the worktop to the
dimensions shown in the diagram. In order to
correctly fit this type of hob, a 3mm deep
recess around the edge of the opening is also
needed.
Note: In case of laminated worktops with a laminate thickness lower
than 3 mm, create a recess as shown as on the detailed schematic
drawing.
Before positioning the hob, apply the adhesive seal supplied on the
bottom perimeter of the hob itself, where this will be in contact with
the worktop (fig. 2).
Once the seal is in position, place the hob in the recess. Fix the hob
to the worktop using the screws and brackets provided, tightening
them carefully until the hob is perfectly flush. (fig. 3).
Carefully trim the excess seal. In case of installation on wood
(particularly chipboard), any small spaces between the edge of the
recess and the outside edge of the hob should be filled with small
quantities of silicon sealant (see fig. 4). Once the appliance has been
installed, the bottom part of the hob should be completely accessible.
Important:
• tighten the fixing brackets of the hob to the work top by hand,
using minimum force.
• In case of wooden (or similar) worktops, before fitting the
adhesive seal protect the surface of the milled recess with a
primer.
Slots for extra brackets have been created on the bottom of the
appliance, to help achieve a more flush positioning (should this be
necessary). Appropriate brackets can be obtained from the Customer
Care Centre.
14:30
Pagina 11
11
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Advertisement
Table of Contents
