LG AMNQ24GTPB0 Installation Manual page 4

SAFETY INSTRUCTIONS
4
• Compliance with national gas regulations shall be observed.
• Ducts connected to an appliance shall not contain an ignition
source. (for R32)
• This unit is equipped with a refrigerant leak detector for safety.
To be effective, the unit must be electrically powered at all
times after installation, other than when servicing. (for R32)
• This unit is equipped with electrically powered safety measures.
To be effective, the unit must be electrically powered at all
times after installation, other than when servicing. (for R32)
• Installation MUST conform with local building codes or, in the
absence of local codes, with the Nation Electrical Code NFPA
70/ANSI C1-1003 or current edition and Canadian Electrical Code
Part1 CSA C.22.1.
Installation
• Always perform grounding.
- Otherwise, it may cause electrical shock.
• Don't use a power cord, a plug or a loose socket which is damaged.
- Otherwise, it may cause a fire or electrical shock.
• For installation of the product, always contact the service
center or a professional installation agency.
- Otherwise, it may cause a fire, electrical shock, explosion or
injury.
• Securely attach the electrical part cover to the indoor unit and
the service panel to the outdoor unit.
- If the electrical part cover of the indoor unit and the service
panel of the outdoor unit are not attached securely, it could
result in a fire or electric shock due to dust, water, etc.
• Always install an air leakage breaker and a dedicated switching
board.
- No installation may cause a fire and electrical shock.
• Do not keep or use flammable gases or combustibles near the
air conditioner.
- Otherwise, it may cause a fire or the failure of product.