4.3 Installation site
requirements
NB!
If the device is tilted more than 40°,
residual water can escape from the
device and cause material damage.
Carefully tilt the device.
▶
Transport the device upright.
▶
Freezing residual water in the device
can damage the device.
Do not place and use the device in
▶
frost-sensitive places or outdoors.
If the device is used immediately after
transportation, the refrigerant in the
device may cause damage to the
device.
Immediately after transport, allow
▶
the device to rest for two hours
before using it.
Place of installation
On the floor
To demand
The device on
a clean, ef-
fen and fasten
place surface.
The device
set
→ Page 16 .
Set up and connect
Place of installation
In a wash-
drying column
On a wall
4.4 Water drain hose
During drying, condensation water forms,
which your appliance collects in the
condensation water container. Ge-
To demand
The device al-
borrow with the
original connection
set of the dry
ger manufacturer
a washer-dryer
set up column.
¡Connection set
with pull-out
work surface
→ Page 29
¡Connection set
→ Page 29
This device already
borrow on a washing
machine from the-
same manufacturer
places. The
depth and width
to of this device
must with
the measurements
of the washing machine
chinese match
man.
The washer-dryer column
do not place on
a platform.
No hoses and
mains connection
between wall and
device clamp-
man.
NL
13