Advertisement
Crown Pad Installation
1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring
that the center and side holes are properly aligned. Press the crown pad plastic sleeve (center portion) into
the center of the channel which is built into the plasticshell base, working your way outward to each side.
2. Align and snap the two rear snaps into place.
Cheek Pad Removal
There are 3 snaps holding the cheek pad in place.
1. Gently pry the cheek pad away from the interior, releasing the snaps.
2. To remove, gently pull the center of the cheek pad.
Cheek Pad Installation
1. Align and fully slide the cheek pad plastic plate between shell and EPS.
2. Clip the cheek pad's 3 small male snaps to the 3 female snaps fixed on the shell interior.
B B
A A
B B
A A
5
Warning!
■
Try not to operate the sun shield while riding as this may impair your vision and may lead to an accident.
■
DO NOT pull on the sun shield when it is already down. The sun shield may be ejected and this will
increase the risk of serious injury or death in the event of an accident.
■
DO NOT attempt to adjust the sun shield itself with your hands. Always use the sun shield lever.
■
DO NOT use sun shield at night time. The sun shield is only for day time use. The sun shield does not
provide eye protection. When you use the sun shield be sure that the clear visor(shield) is also in closed
position.
Sun shield Operation
Lever
Stopper
Lever
Above illustration shows raised sun shield position.
Above illustration shows lowered sun shield position.
Stage 3
Stage 2
Stage 1
There are three positions for the sun shield sliding lever.
Stage 1 - Standard position
Stage 2 - Lower position
Stage 3 - Lowest position
6
Advertisement
