GE JGBS06 Owner's Manual & Installation Instructions page 23

Installation
Instructions
Range
I If you have questions, call 1.800.432.2737.
I
INTHE COMMONWEALTH OF
MASSACHUSETTS
• This product must be installed by
a licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be theT-handle type.
• A flexible gas connector, when used,
must not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
Installation of this range must conform with
local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI
Z223.1/NFPA.54, latest edition. In Canada,
installation must conform with the current
Natural Gas Installation Code, CAN/CGA-
B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local
codes where applicable. This range has
been design-certified by CSA International
according to ANSI Z21.1, latest edition
and Canadian Gas Association according
to CAN/CGA-I.1 latest edition.
As with any appliance using gas and
generating heat, there are certain safety
precautions you should follow.You will find
these precautions in the Important Safety
Information section in the front of this
manual. Read them carefully.
• IMPORTANT - Save t hese
instructions for local inspector's use.
• IMPORTANT - Observe all
governing codes and ordinances.
• Note to Installer- Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keep these
instructions for future reference.
• Note-This appliance must be properly
grounded.
• Servicer-The electrical diagram is in an
envelope attached to the back of the range.
• Skill Level -Installation of this appliance
requires basic mechanical skills.
• Proper installation is the responsibility of
the installer.
Product failure due to improper installation
is not covered under the Warranty.
23