GE JGBS06 Owner's Manual & Installation Instructions page 21

GEApplianees.com
Grid
I
I I
I
/
I
I I
I '_ I
,,,%,-
Broiler Pan and Grid
After broiling, remove file broiler pan from
the oven. Remove the grid from the pan.
Carefldly pour out grease from the pan
into a proper containeL Wash and rinse
the broiler pan and grid in hot wamr
with a soap-filled or plastic scoudng pad.
If food has burned on, sprinkle die grid
with demIgent while hot and cover with
wet paper towels or a dishclodL Soaking
the pan will remove burned<m foods.
The broiler pan and gild may be cleaned
wkb a commercial oven cleaneL
Both the broiler pan and grid can also be
cleaned in a dishwasheL
Do not store a soiled broiler pan and grid
anDvhere in the range.
A CAUTION: D onor ,e n,he roi,er
panor gridin a self<leanbgoven.
Removable Broiler Drawer (on some models)
Toremove:
When tile broiler is cool, remove tile
giJd and pan.
[_] Pull the broiler drawer out until it
i¢-i
stops, then push it back in about
one inch.
Toreplace:
Hold the broiler drawer in die IMsed
position as you slide it parta,vay into die
range. Then lower the drawer and push
it complemly closed.
[_ Grasp the handle, lift and pull tlle
broiler drawer out. Clean the broiler
drawer with hot soap), wateL
Vent appearance and location vary.
Oven A# Vents
Never block the vents (air openings) of die
range. They provide the air inlet and oudet
that are necessm T for the range m opemm
properly with correct combustion.
Air openings are locamd at tile rear of
file cooktop, at file top and bottom of the
oven dooI; and at the bottom of the range,
under the broiler dmweL
Pull the knob straight off the stem.
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe die conuol panel
after each use of die oven. Use a damp
cloth m clean or rinse. For cleaning, use
mild soap and
water
or a 50/50 solution
of vinegar and wamL For rinsing, use
clean WamL Polish di T with a soft cloth.
Do not use abrasive cleanseis, suong
liquid cleaners, plastic scoudng pads or
oven cleaners on the control panel--
they will damage the finish.
Do not bend Mlobs by pulling them up or
down or by hanging a towel or odler such
loads. This can damage the gas valve shaft.
The conuol knobs may be removed for
easier cleaning. To remove a knob, pull
it smdght off the smm. If knob is difficult
m remove, place a towel or dishcloth
between the knob and control panel and
pull gendy. Wash the knobs in soap and
wamr or a vinegar and hot wamr solution.
Metal parts can be cleaned wifll soap
and WamL Do not use smel wool,
abrasives, ammonia, acids or commercial
oven cleaneis. DIT with a soft cloth.
21