Toro Reelmaster 3550 Series Installation Instructions Manual page 2

Media and Additional Parts
Description
Installation Instructions
Parts Catalog
Note: Determine the left and right sides of the cutting unit
from behind the cutting unit.
Important: Use the Rear Roller Brush Kit only when
cutting in the height-of-cut range of 6 to 25 mm (1/4 to
1 inch). Use the High Height of Cut Brush (Part No.
121-3199) when cutting above 25 mm (1 inch). Refer to
the procedure for Installing High Height of Cut Brush.
The Rear Roller Brush Kit (Model 03917) may be used
on the following:
Cutting Unit Model (5) 03911, (5) 03912, (5) 03480, (5) 03481,
(5) 03485, and (5) 03486 for the Reelmaster 3550 Traction
Unit with (3) 03914 left-hand and (2) 03915 right-hand
groomer kits.
Gathering the Items Required
for Installation
Acquire the following tools before proceeding with the
installation:
•
1/2 inch deep-well socket
•
9/16 inch deep-well socket
•
1/2 inch wrench
•
9/16 inch wrench
•
5/16 inch hex key
•
12 inch straightedge (Toro Part No. 114-5446)
•
Torque wrench 20 to 25 N∙m (15 to 19 ft-lb)
•
Torque wrench 36 to 45 N∙m (27 to 33 ft-lb)
•
Torque wrench 47 to 54 N∙m (35 to 40 ft-lb)
•
Torque wrench 115 to 128 N∙m (85 to 95 ft-lb)
•
Torque wrench 2 to 3 N∙m (20 to 25 in-lb)
•
Blue 242 Loctite
Determining the Roller Brush
Orientation
All cutting units are shipped with the counter weight mounted
to the left end of the cutting unit. Use
the position of the roller brush and reel motors.
Qty.
1
1
Figure 1 to determine
2
Read the instructions before installing and operating.
Use the parts catalog to look up replacement parts.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note: These instructions and illustrations show the
installation of the kit on cutting units with the end weights
mounted on the left end of the cutting unit.
Installing the Roller Brush
Preparing to Install the Roller-Brush
Assembly
1. Remove the 2 flange nuts securing the groomer access
cover to the groomer cover and set them aside
2).
2. Remove the 2 flange-head bolts securing the groomer
cover plate and gasket to the groomer access cover
(Figure 2).
Note: Discard the bolts, the cover plate, and the
gasket.
3. Remove the 2 groomer cover mounting nuts and save
them.
Use
Figure 1
5. Cutting unit 5
6. Reel motor
7. Right roller-brush drive
assembly
8. Left roller-brush drive
assembly
(Figure