Toro Reelmaster 3550 Series Installation Instructions Manual page 7

B. If the pulleys are not aligned, refer to
the Pulley Alignment (page
If the pulleys are aligned, continue with the
installation.
Note: Do not use the idler pulley to check the
alignment.
Important: The belt may fail prematurely if
the pulleys are not properly aligned.
2. Install the groomer access cover
g021353
Figure 14
1. Groomer access cover
2. Gasket
3. Slide the belt cover onto the mounting bolts and secure
with 2 flange nuts.
Note: Carefully install the rear roller brush cover to
prevent damage or pinching to gasket.
Important: Do not overtighten the nuts, or the
cover may become damaged.
4. Lubricate the grease fittings on each of the roller-brush
bearing housings and on the remainder of the cutting
unit with No. 2 lithium grease
Figure 15
Checking
9).
(Figure 14).
3. Belt cover
(Figure 15).
5. Wipe off any excess grease, especially around the
excluder seals.
Installing the High
Height-of-Cut Brush (Optional)
Install the High Height of Cut Brush (Part No. 110-1740)
when cutting above 2.5 cm (1 inch) height of cut (5 or more
spacers installed below the side plate pad).
1. If a roller brush is installed on the cutting unit, remove
the 2 bolts, washers and nuts securing the non-drive
bearing housing to the bearing housing mounting
bracket (Figure
3
2
1
1. Non-drive bearing housing 4. Washer (2)
2. Mounting bracket
3. Flange nut (2)
2. Slide the non-drive bearing housing and excluder seal
off the brush shaft
1
1. Non-drive bearing housing 3. Brush shaft
2. Excluder seal
3. Remove the 2 J-bolts and nuts.
7
16).
Figure 16
5. Bolt (2)
(Figure 17).
3
2
G020301
Figure 17