Safety Information; For Outdoor Use Only - Dometic SAFARI CHEF 30 User Instructions

Hide thumbs Also See for SAFARI CHEF 30:
Table of Contents

Advertisement

Provide ample ventilation. This gas appliance consumes air (oxygen). Do not use this appliance in an unventilated space to
avoid endangering your life. If still more gas appliances and/or occupants using gas are added to the space, additional ventilation must
Read these instructions carefully so as to familiarise yourself with the appliance before fitting the appliance to a gas cylinder.

1. Safety information

This appliance complies with AS/NZS 2658.
Gas appliances require ventilation for efficient performance and to ensure the safety of
users and other persons in close proximity, do not use the appliance in an unventilated
area. It is intended for outdoor use only.
WARNING: ACCESSIBLE PARTS MAY BE VERY HOT. KEEP YOUNG CHILDREN AWAY.
Read these instructions carefully before using the appliance.

FOR OUTDOOR USE ONLY!

Assembly and use
The Safari Chef 30 is designed to utilise various cooking surfaces. Various food types can
be prepared on this appliance.
Do not use the appliance if it has damaged or worn seals.
Do not use an appliance that is leaking, damaged or which does not operate properly.
Always operate the appliance on a firm level surface.
Ensure that the assembled product is stable and does not rock.
This appliance is not suitable for installation or connection to a reticulated gas supply.
This appliance must be kept away from flammable materials during use. Minimum safe
distances are: Above the appliance 1.2m. At the rear and sides 600mm (See fig. 1).
When using a pot, the minimum recommended pot size is 180mm and maximum recommended size is 250mm.
Do not use any cooking surface or pot that is larger than the recommended size. Our cooking surfaces have been specifically designed to
allow gas conbustion to escape and the closer of this space could affect the performance of this appliance.
Do not modify this appliance.
The unit is supplied with a convenient carry bag.
Hose
The hose must be checked for wear or damage before every use and before connecting to the gas container.
Do not use the appliance if it has a damaged or worn hose. Replace the hose.
The minimum hose length is 600mm and it is recommended that the maximum hose length should not exceed 1.5m.
Gas Container
Gas is supplied to the unit via a hose and regulator, connected to a gas cylinder not exceeding 9kg.
Depending on the hose and regulator model you have purchased, this appliance shall only be used with (i) a Type 27 refillable 4.5-9kg
ULPG cylinder certified to AS 2030 and AS 2469, (ii) 1LB Propane cartridge certified to DOT-39, or (iii) 80/20 Butane/Propane cartridge
certified to EN417.
IT COULD BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CARTRIDGES.
This appliance shall only be used with an approved hose and regulator complying with AS/NZS 1869 and AS 4621.
Only to be used with a gas cylinder that does not exceed 500mm in height (including the regulator) and 350mm in width.
Ensure that the gas container is fitted or changed in a well-ventilated location, preferably outdoors, away from any sources of ignition such
as naked flames, pilots, electric fires and away from other people.
Keep gas containers away from heat and flame. Do not place on a stove or any other hot surface.
Refillable containers are to be used only in the upright position so as to ensure proper fuel withdrawal. Failure to adhere to this may cause
liquid discharge from the gas container resulting in a dangerous operating conditions.
Do not try to remove the gas container whilst the appliance is in operation.
The gas container must be disconnected from the appliance after use or when in storage.
Not for use with a remote gas supply.
Light back
In the event of light back (where the flame burns back and ignites inside the burner or venturi housing), immediately turn off the gas supply
by firstly closing the control valve on the gas cylinder and then the appliance valve. After the flame is extinguished, remove the regulator
(when using a hose and regulator) and check the condition of the seal; replace the seal if in doubt. Re-light the appliance.
Should the flame persistently light back, return the product to your authorized repair agent.
Leaks
If there is a gas leak on your appliance (smell of gas), immediately turn off the gas supply by turning the control knob clockwise to the "OFF"
position and take it into a flame free location where the gas leak may be detected and stopped. If you wish to check for gas leaks on your
appliance, do it outside. Do not try to detect gas leaks using a flame; use soapy water.
For appliances for use with cylinders
If there is a gas leak on your appliance (smell of gas), immediately attempt turn off the cylinder valve. Remove the appliance to a well-ventilated
location away from any ignition source. Check for leaks using soapy water. Do not try to detect leaks using a flame.
For appliances for use with cartridges:
• If there is a gas leak from your appliance (smell of gas) and you cannot stop the gas flow, remove the appliance to a well-ventilated location
away from any ignition source. Check for leaks using soapy water. Do not try to detect leaks using a flame.
CAUTION
be provided.
IMPORTANT
Retain these instructions for future reference.
1 1
EN
Fig. 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

6540l1

Table of Contents