Philips Sonicare One HY1200 Manual page 4

Travelling
Note: Depending on the model purchased,
your Philips One comes with a travel case or
travel cap to store your power toothbrush
when travelling or between uses.
Travel case
Put your Philips One toothbrush in the travel
case with the bristles facing downwards. Snap
close the lid of the travel case.
To remove your Philips One toothbrush in the
travel case, follow these steps:
1 Flip open the travel case lid.
2 While holding both ends of the travel case,
pinch the base of the toothbrush (Fig. 7).
3 The toothbrush will raise. Lift the
toothbrush.
Brush head travel cap
Place your Philips One brush head inside the
enclosure of the brush head travel cap with
bristles facing upwards. Press the two sides of
the cap together to close (Fig. 8).
To remove the brush head travel cap:
1 Ensure the cap is facing upward and the
handle is facing you.
2 Hold each side of the cap with opposite
hands, pushing down on the right side of
the cap while using the other hand to
gently open the left side in the direction of
the arrow (Fig. 9).
Using your Philips One toothbrush
If you are using this toothbrush for the first
time, it is normal to feel more vibration than
when using a manual toothbrush. The Philips
One uses microvibrations to help gently clean
your teeth. Please follow the brushing
instructions below for the best experience.
Philips One comes with a SmarTimer and
QuadPacer to help you brush evenly
throughout your mouth.
SmarTimer
The SmarTimer indicates that your 2-minute
brushing cycle is complete by beeping 3 times
and automatically turning off.
Note: Dental professionals recommend
brushing no less than 2 minutes twice a day.
QuadPacer
The QuadPacer is an interval timer that beeps
every 30 seconds to remind you to brush all
teeth evenly by dividing your mouth into 4
sections (Fig. 10).
Begin brushing in section 1 (outside upper
teeth) and brush for 30 seconds before you
move to section 2 (inside upper teeth).
Continue brushing in section 3 (outside lower
teeth) and brush for 30 seconds before you
move to section 4 (inside lower teeth).
Note: If you press the power button after you
started the brushing cycle, the toothbrush will
pause. After a pause of 30 seconds, the
SmarTimer and QuadPacer reset.
Brushing instructions
Please follow the brushing instructions for the
best experience.
1 Wet the bristles and apply a small amount
of toothpaste.
2 Place the toothbrush bristles against the
teeth at a slight angle (45 degrees) (Fig.
11), pressing gently to make the bristles
reach the gumline or slightly beneath the
gumline.
Note: The bristles should slightly flare.
3 Press the power button to turn on the
toothbrush.
4 Brush your teeth with back and forth
strokes so that the bristles reach all surfaces
of the teeth. Change to another section
when the QuadPacer beeps. Continue this
motion throughout the 2-minute brushing
cycle.
5 To clean the inside surfaces of the front
teeth, tilt the brush vertically and make
several up-and-down strokes (Fig. 12).
6 After you have completed the brushing
cycle, you can spend additional time
brushing the chewing surfaces of your
teeth and areas where staining occurs (Fig.
13). You can also brush your tongue, with
the toothbrush turned on or off, as you
prefer.
Your power toothbrush should be safe to use
on braces (brush heads wear out sooner when
used on braces) and dental restorations
(fillings, crowns, veneers) if they are properly
adhered and not compromised. If a problem