Table of Contents
Advertisement
8
ADDING / REMOVING FAN4-CONTROL FROM Z-WAVE NETWORK
This section describes how to add and remove Fan4-Control from Yubii Home gateway. There are 2 possible ways to make it.
8.1 Adding device using the manual method
1. Set the Yubii Home into add mode (see the Yubii Home manual).
2. In the home page, long press
on the interface.
Note:
If there is number displayed it means that device has been already added to the network. In case of re-adding please follow
the procedure of removing the device from the network first (described below) or restore the device to factory defaults.
M
3. Press
to include the device into Z-Wave network, if the inclusion is successful, it will show node number in the Z-wave network.
8.2 Adding device using the SmartStart method
To add Fan4-Control to the Z-Wave network using SmartStart:
1. Scan the DSK QR code or input the underlined 5-digit PIN code (label on the side of the box and on the device).
2. Power the device (turn on the mains voltage).
3. Successful adding will be confirmed by the Z-Wave indicator on the display.
8.3 Removing device from Yubii Home
1. Set the Yubii Home into exclusion mode (see the Yubii Home manual).
2. In the home page, long press
on the interface. Please note that if a device has been added to the gateway It should be displaying number different from "--".
M
3. Press
to exclude the device from Z-Wave network, if the exclusion is successful, it will show 000 in the interface.
+
synchronously for 3 sec, Fan4-Control enters into adding mode displaying product "--"
+
synchronously for 3 sec, Fan3-Control enters into removing mode displaying existing product ID
Advertisement
Table of Contents
