Table of Contents
Advertisement
Assembly & Set-Up
Contents of Carton
•
One Snow Thrower
•
One Snow Thrower Operator's
Manual
Assembly
Handle
1.
Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. See Fig. 3-1.
NOTE: Make certain the upper ends of each cable are
seated properly in its pulley. See Fig. 3-2.
Figure 3-1
2.
Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
1.
Position the chute assembly over the base. See Fig. 3-3.
•
Two Replacement Auger Shear Pins
•
One Engine Operator's Manual
•
One Chute Assembly
•
One Product Registration Card
Figure 3-2
Figure 3-3
3
7
Advertisement
Table of Contents
