BMW 4 Coupe Series Manual page 119

Turning on/off
Press the button.
A Check Control message is displayed.
If the trip is resumed within approx. 15 minutes
after an intermediate stop, the steering wheel
heating turns on automatically if the function was
turned on at the completion of the last trip.
Memory function
Principle
The following settings can be stored and, if nec‐
essary, retrieved using the memory function:
▷ Seat position.
▷ Exterior mirror position.
▷ Height of the Head-up Display.
General information
Two memory locations with different settings
can be set for each driver profile.
The following settings are not stored:
▷ Backrest width.
▷ Lumbar support.
Safety information
Warning
Using the memory function while driving can
lead to unexpected seat or steering wheel
movements. Vehicle control could be lost.
There is a risk of accident. Only retrieve the
memory function when the vehicle is stationary.
Seats, mirrors and steering wheel
Online Edition for Part no. 01405A392C9 - VI/21
Warning
There is a risk of jamming when moving the
seats. There is a risk of injury or risk of damage
to property. Make sure that the area of move‐
ment of the seat is clear prior to any adjust‐
ment.
Overview
The memory buttons are located on the driver's
door.
Storing
1. Set the desired position.
2. Press the button. The writing on the
button lights up.
3. Press desired button 1 or 2 while the LED is
lit. A signal sounds.
Calling up settings
Press the desired button 1 or 2.
The stored position is called up.
The procedure stops when a switch for setting
the seat is pressed or one of the memory but‐
tons is pressed again.
The adjustment of the seat position on the driv‐
er's side is interrupted after a short time while
driving.
CONTROLS
119